MAC TOOLS MW250 Provozní pokyny stáhnout pdf (Strana 219)

100

101

TM 5-4310-452-14

4-81. DATA PLATES, DECALS, AND INSTRUCTION HOLDERS REPLACEMENT.

This Task Covers:

a. Removal of Data Plates and Instruction Holders c. Removal of Warranty Decal

b. Installation of Data Plates and Instruction d. Installation of Warranty Decal Holders

Initial Setup:

Equipment Conditions: Materials/Parts:

• Engine off. • Drive screws (as required)

Tools/Test Equipment: • Rivets (as required)

• General mechanic's tool kit

• Electric drill

• Rivet gun

• Twist drill bit

a. REMOVAL OF DATA PLATES AND INSTRUCTION

HOLDERS

NOTE

Use this task to remove any 1 of 13

data plates and instruction holders.

Trailer operating instructions data

plate is shown.

1. Using electric drill and twist drill bit, remove rivets or

drive screws (1) holding data plate (2) in place on

compressor unit.

2. Remove data plate (2).

b. INSTALLATION OF DATA PLATES AND

INSTRUCTION HOLDERS

1. Position data plate (2) in place on compressor unit.

2. Install rivets or drive screws (1) as required to hold

data plate in place.

4-161

1 2 ... 214 215 216 217 218 219 220 221 222 223 224 ... 404 405

Komentáře k této Příručce

Žádné komentáře

MAC TOOLS MW250 Provozní pokyny Strana 219

Komentáře k této Příručce

Související produkty a manuály pro Svařovací systém MAC TOOLS MW250