MAC TOOLS MW250 Provozní pokyny stáhnout pdf (Strana 153)

100

101

TM 5-4310-452-14

4-47. SAFETY CIRCUIT BYPASS SWITCH REPLACEMENT.

This Task Covers:

a. Inspection c. Installation

b. Removal

Initial Setup:

Equipment Conditions: Tools/Test Equipment:

• Engine off. • General mechanic's tool kit

• Battery cables disconnected (see paragraph • Multimeter

4-57).

• Left door assembly open.

a. INSPECTION

1. Remove 2 electrical leads (2) from switch terminals

(3). Visually inspect switch (4) for damage or

broken switch terminals.

2. Using multimeter, test switch (4) for continuity and

function. Replace switch if damaged or defective.

b. REMOVAL

1. Remove boot (6) and nut (5) from switch (4).

Remove switch from control panel (1).

c. INSTALLATION

1. Position switch (4) in place in control panel (1). Install nut (5) and boot (6) on switch.

2. Install 2 electrical leads (2) on switch terminals (3).

FOLLOW-ON TASKS:

• Connect battery cables (see paragraph 4-57).

• Close left door assembly.

TA505477

4-91

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 404 405

Komentáře k této Příručce

Žádné komentáře

MAC TOOLS MW250 Provozní pokyny Strana 153

Komentáře k této Příručce

Související produkty a manuály pro Svařovací systém MAC TOOLS MW250