MAC TOOLS MW250 Provozní pokyny stáhnout pdf (Strana 218)

100

101

TM 5-4310-452-14

4-80. TOOL BOX PAD REPLACEMENT.

This Task Covers:

a. Removal b. Installation

Initial Setup:

Equipment Conditions: Materials/Parts:

• Engine off. • Tool box pad (as required)

Tools/Test Equipment: • Plastic clips (as required)

• General mechanic's tool kit

a. REMOVAL

NOTE

Use this task to remove any 1 of 4 tool box pads, Right rear tool box pad is shown.

1. Release 2 clamping catches (5) on tool box (4) and

open tool box lid (1).

2. Remove plastic clips (2) and tool box pad (3) from

tool box (4). Discard tool box pad and plastic clips.

b. INSTALLATION

1. Install new tool box pad (3) and plastic clips (2) in

tool box (4),

2. Close tool box lid (1) and latch 2 clamping catches

(5).

4-160

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 404 405

Komentáře k této Příručce

Žádné komentáře

MAC TOOLS MW250 Provozní pokyny Strana 218

Komentáře k této Příručce

Související produkty a manuály pro Svařovací systém MAC TOOLS MW250